Top positive review
21 September 2018
Okay, this is good!
Il help you out with the step by step process on how to get this placed on the camera
Note : Now the bezel and the lens are attached with the help of the glue. The only thing that would come in your way is the glue
1. First insert a sharp object inside that two gaps near the bezel and try sliding it futher thus cutting the glue as you move further. As the entire area is done by the edges the bezel would pop out easily
2. I found the lens part a tad bit difficult. I used a blade to stick between the gap of the lens and then holding on which it was placed. Perform the same step as above on moving further cutting the glue.
Note : The lens would still have some resistance that is because the glue is at the center area too carefully cut the sticky glue with a blade removing the lens pulling the lens gently and it should come out.
The led caps in my case were attached to the lens itself so carefully remove the caps and place it in the apt place
The cap would have to holders to be inserted in the lens contour
Just tab the lens with a micro fiber cloth to make sure no glue particles are in the way of the lens
3. Take the new lens and remove the blue sticker and hold it without touching the part where the glue is applied. ( If touched it is still fine as you don't drag your finger over the lens just remove it directly )
Place the lens properly on the holding and use the fiber cloth to remove the air present and remove the plastic coating
And voila you have gifted yourself a new camera!
Now the only thing that will worry me and the rest that it should resist scratches as it is being used. If this is not possible then it is of no use
The only pros is that it's just 250 bucks.